美國原裝 Tag Connector TC2050-IDC-NL-430(14Pin)

TC2050-IDC-NL 14-Pin No-Legs Cable with Ribbon connector

　　Special version of the TC2050-IDC-NL Plug-of-Nails™ “No legs” cable designed to be plugged directly into TI’s MSP-FET430, compatible with all MSP430 MCU’s.

　　Tag-Connect’s TC2050-IDC-430-NL programming cable is a special version of the TC2050-IDC-NL Plug-of-Nails™ cable designed to be plugged directly into TI’s MSP-FET430 and is compatible with all MSP430 MCU’s. The cable is fitted with a spring-pin Tag-Connector that conveniently plugs directly into your PCB and terminates in a 14-pin 0.1″ ribbon connector that plugs directly into the FET430.

• The cable is fitted with a spring-pin Tag-Connector.
• The cable is fitted with a spring-pin Tag-Connector.
• Plugs straight to your PCB – No mating connector or header required!
• Requires only a tiny 0.03 square inch footprint of pads and locating holes in your PCB.
• Footprint MUCH smaller than the standard 14-pin ribbon header.
• Zero Cost Per Board!
• High-Reliability Spring-Pins make a Secure Connection and are rated for over 100,000 operations.
• Footprint has no height and reduces the size and space requirements of your PCB.
• Can be retained in place using a TC2050-CLIP board.
  

　　Tag-Connect cables provide a simple, reliable means of connecting Debuggers and Programmers or other test equipment to your PCB’s while lowering board costs and facilitating efficient production programming.

　　Tag-Connect uses a specially designed (Patent Pending) connector which eliminates the need for putting a programming header or other mating connector on every PCB. Instead, Tag-Connect uses tried and tested spring-pins rated for over 100,000 operations to make a secure connection to a special footprint pattern of pads and locating holes in your PCB.

　　The legged ‘No Legs’ footprint takes about the same board space as a couple of SMT resistors which means you can locate the footprint right next to the MCU if desired. If required, use the TC2050-CLIP board to secure the TC2050-IDC-430-NL connector to the PCB.

　　The ‘No Legs’ Tag-Connector is also compatible with the ‘Legged’ footprint, meaning you can conveniently debug with the self-retaining TC2050-IDC-430 and use TC2050-IDC-430-NL for a quick hand-held programming operation as may be typical during production.

　　This 10-conductor cable has a TC2050 Tag-Connector on one end and a standard 14-pin ribbon connector on the other and is wired specifically for the TI MSP-FET430 debugger (and compatible MSP430 debuggers). It is compatible with all MSP430 MCU’s.