產品說明0
美國原裝 Tag Connector TC2050-IDC-NL-430(14Pin)
TC2050-IDC-NL 14-Pin No-Legs Cable with Ribbon connector
Special version of the TC2050-IDC-NL Plug-of-Nails™ “No legs” cable designed to be plugged directly into TI’s MSP-FET430, compatible with all MSP430 MCU’s.
Tag-Connect’s TC2050-IDC-430-NL programming cable is a special version of the TC2050-IDC-NL Plug-of-Nails™ cable designed to be plugged directly into TI’s MSP-FET430 and is compatible with all MSP430 MCU’s. The cable is fitted with a spring-pin Tag-Connector that conveniently plugs directly into your PCB and terminates in a 14-pin 0.1″ ribbon connector that plugs directly into the FET430.
- The cable is fitted with a spring-pin Tag-Connector.
- The cable is fitted with a spring-pin Tag-Connector.
- Plugs straight to your PCB – No mating connector or header required!
- Requires only a tiny 0.03 square inch footprint of pads and locating holes in your PCB.
- Footprint MUCH smaller than the standard 14-pin ribbon header.
- Zero Cost Per Board!
- High-Reliability Spring-Pins make a Secure Connection and are rated for over 100,000 operations.
- Footprint has no height and reduces the size and space requirements of your PCB.
- Can be retained in place using a TC2050-CLIP board.
Tag-Connect cables provide a simple, reliable means of connecting Debuggers and Programmers or other test equipment to your PCB’s while lowering board costs and facilitating efficient production programming.
Tag-Connect uses a specially designed (Patent Pending) connector which eliminates the need for putting a programming header or other mating connector on every PCB. Instead, Tag-Connect uses tried and tested spring-pins rated for over 100,000 operations to make a secure connection to a special footprint pattern of pads and locating holes in your PCB.
The legged ‘No Legs’ footprint takes about the same board space as a couple of SMT resistors which means you can locate the footprint right next to the MCU if desired. If required, use the TC2050-CLIP board to secure the TC2050-IDC-430-NL connector to the PCB.
The ‘No Legs’ Tag-Connector is also compatible with the ‘Legged’ footprint, meaning you can conveniently debug with the self-retaining TC2050-IDC-430 and use TC2050-IDC-430-NL for a quick hand-held programming operation as may be typical during production.
This 10-conductor cable has a TC2050 Tag-Connector on one end and a standard 14-pin ribbon connector on the other and is wired specifically for the TI MSP-FET430 debugger (and compatible MSP430 debuggers). It is compatible with all MSP430 MCU’s.
If your MSP430 device supports SPY-BI-WIRE, also take a look at the SPY-BI-TAG adaptor with the even smaller footprint (0.02 square inches) TC2030-MCP-NL 6-pin cables. This is the perfect solution where board space is premium!
相關文件
Documents & Media
Datasheets
This product is used in the following debugger/device solutions:
This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.
